Troubleshooting guide

9
If staples are being loosely clinched, requiring that the clinchers be raised or lowered, proceed as
follows:
Remove the clincher guard (1) . Loosen the clincher adjustment binder screw (2). Rotate the
clincher adjustment screw (3) to raise or lower the clincher points as needed.
Retighten the binder screw (2) and attach the clincher guard (1). Turn the machine over manually a
few revolutions and ensure that the machine if operating freely before running under power.
Raising or Lowering the Clinchers (See Figure 3)
Always disconnect the power supply before
making any adjustments or servicing the stitcher.
WARNING
!
Figure 6 - Wire Straightening