Troubleshooting guide

7
(see above). Locate the actuator assembly on the wrap spring clutch and push the actuator to pivot it
away from the control collar cam, releasing the brake. The machine will rotate one revolution when
the large drive pulley is turned manually in the direction of the arrow on the pulley (top of pulley
toward front of machine).
Turning Machine Manually
Always disconnect the power supply before making any
adjustments or servicing the stitcher.
WARNING
!
Operating Adjustments
The quality and quantity of work that can be stitched on the M2 is dependent upon the operator
making the various operating adjustments as accurately as possible. The following information
and instructions are provided so that the operator will clearly understand how to make the required
operating adjustments.
Adjusting the Machine for Thickness of Work (See Figure 2)
Turn the thickness adjustment handwheel (1) clockwise until the gage spool (2) is raised sufficiently
to allow a sample of work to be inserted between the gage spool and its lower stop.
With the work held in this position, turn the handwheel (1) counter-clockwise until the work is
firmly clamped between the gage spool (2) and the stop.
Turn the handwheel back clockwise just enough to allow the work to be withdrawn from the gage,
then return the handwheel to the setting at which the work was firmly clamped.