Troubleshooting guide

The DeLuxe Stitcher M2 Book Stitcher is a combination light & heavy duty stitcher
designed to staple both flat and saddle work ranging in thickness from a few sheets to 1/4"
for 2601 heads, 5/16" (8mm) for G8 heads.
The recommended wire sizes to be used on the M2 are as follows: 25 to 30 round wire
for 2601 heads, 24 to 28 for G8 heads.
The M2 is easily adjusted from saddle work to flat work by means of tilting the 5-1/2"
(14cm) x 26" (66cm) work table. An adjustable work guide and adjustable work stops
are easily attached to the work table and provide for accurate registering of flat work for
uniform spacing of staples.
The M2 is footswitch operated and is belt driven by a 1/2 HP motor, making possible
operating speeds up to 215 stitches per minute. The motor is mounted on an adjustable
bracket which can be raised or lowered for adjusting the driving belt tension. The machine
driving mechanism is thoroughly shielded thus preventing the possibility of personal
injury.
The M2 has a 14" (35.6cm) throat depth for both flat and saddle stitching. The work table
is approximately 34" (86.4cm) above the floor, and there is approximately 17/32" (24mm)
clearance between the top of the work table and the stitching head.
The M2 weighs approximately 325 lb (145 kgs) net, shipping weight is approximately
3 80 lb (I 72 kgs). With the table installed, the M2 requires about 28" (71.1 cm) x 30"
(76.2cm) of floor space.
Because of the length of the work table, the M2 must be secured to the floor to meet
CE stability requirements. Sound level readings at the normal operator position are
approximately 84 dBC.
Introduction
4