Troubleshooting guide

Note: At this point it may be necessary to reselect one (1) of the nine (9) Control Collar slots for the
Brake Spring Tang (release Actuator Lever, remove Clutch Spring Tang from slot, then move Control
Collar axially toward the Input Hub end and rotate it opposite to the drive direction to pick up the next
slot). Continue to select Control Collar slots until the 0.38" to 0.50" specification is achieved.
Assemble Retaining Ring to Output Shaft at the Input Hub end (smooth surface facing Input Hub).
Check end play between Input Hub and Retaining Ring with feeler gauge. There should be 0.002" to
0.003" end play on the Input Hub.
Reassemble unit to machine.
IMPORTANT: After Clutch is assembled to machine, the Clutch Plate should be free to float on
bearing - the anchor strap is only there to prevent rotation of the plate.
Figure 5 - Clutch-Brake
19