Troubleshooting guide

To insure continuous operation of the M2 Stitcher, the operator should be sure that the machine is
regularly lubricated and carefully maintained. The operator should periodically inspect all moving
parts for signs of wear and, when required, replace the worn parts.
The following instructions are provided so that the operator will understand how to lubricate the
machine, and how to adjust the clutch.
Lubrication (See Figure 4)
Figure 4 - Lubrication Points
If the machine is operated on work thicker
than it is set to handle, damage will result.
WARNING
!
10
Maintenance
Use an S.A.E. No. 10 oil for lubricating the M2 Stitcher. Machines that are in constant use should
be lubricated daily. Machines that are operated periodically should be lubricated just prior to use.
Usually only a drop of oil is required at each lubrication point in the Stitcher. After lubricating the
machine, wipe off any excessive oil.
Refer to the stitcher head Operation Manual for additional lubrication points on each stitching head.