Specifications

23
the Wire Cutter Operating Slide Friction Spring and place these pieces along side of the Bonnet.
Release the Swivel (9038A or 9038M) from the Swivel Holder (2147 or 9043B) by lifting the Swivel
Operating Spring (2155A or 9046A) off of the Swivel. Continue to rotate the Spring upward until it
can be released from the Swivel Operating Lever Stud (2152 or 9127); until it is approximately at an
11 o’clock position. Remove the Swivel Operating Lever Hub (2154) from the Stud. The 26D style
Heads have a Screw (9058) securing the Stud to the Bonnet, thus securing the Hub to the Bonnet as
well. Remove this Screw in order to remove the Stud and Swivel Operating Lever (2151A). Remove
any accessories at this time in addition to the Swivel Holder.
Figure 19 - Disassembling the Head
2132BA
2146CA
2154
9056 (3)
2155A
9038A or
9038M
UA2305.2 (3)
0084
9048 (2)
9022
9075
2651
2608
2142A or
2627A
9013BA
2152
9127
9058
2151A
9025
9036A
9032
9037
2606
2607
9034
* Parts shown in outline are separated for identification purposes only.
2611
LW8
2147
2137A or
2623A
9046A
9043B
9163
9012A
9512A
9712A