Specifications

In addition to proper lubrication, routine cleaning is important for the maintenance of your 26/26D
Head. The entire Head should be torn down and rebuilt every three months and the following areas
should be cleaned once a month:
• Swivel Assembly (9038A or 9038M): remove and wash in an oil-dissolving solvent, dry
and relubricate.
• Swivel Holder (2147 or 9043B): clean inside the Swivel hole.
• Swivel Operating Lever Hub and Stud: remove the Swivel Operating Spring (2155A or 9046A),
Lever (2151A) and/or Lever Hub (2154). Clean the Swivel Operating Spring Stud (2156) and the
hole in the Hub, relubricate and replace.
Note: Use care when replacing the Swivel Operating Lever and/or Lever Hub to avoid serious
damage being done to the head.
• Anywhere that dust, oil or pieces of wire and paper have built up - for example: the Grip,
Clincher Points and around the Wire Straightener Rollers.
19
• the top of the Bonnet (2601B) on either
side of the Wire Guide Spring Bracket
(2651).
• the oil hole in the Swivel Operating Lever
Hub (2154).
• the oil holes in the Face Plate (2146CA).
• on the Bender Bar Latch (9014) and on the
Grip (9015).
• the opening in the Swivel Holder (2147 or
9043B).
• where the Clincher Points pivot.
• the hole in the Wire Cutter (9048) Holder.
• on the Wire Straightener Rollers (9065) and
Tension Pawl (9098).
2001DHD and 2301DHD styles only
• the oil hole in the Driving Shaft Connection
Link (2215)
• the diameter of the Swivel (9038A or
9038M)
Figure 13 - Lubrication and Cleaning
Cleaning ( Figure 13)
2154
9065
2147 or
9043B
9038A or
9038M
9098
2146CA
2651
9014
9015
9048
2215
2156
2155A or
9046A