Specifications

15
The overall length of the stitch is controlled by the amount of wire that is drawn from the spool
after each stroke of the stitcher machine. To change the overall length of the stitch, the stitcher head’s
Face Plate has be to be raised or lowered accordingly.
2001DHD Series Head (Figure 8)
Loosen the Eccentric Binder Screw found on
the stitcher machine behind the right side of the
Stitcher Head. Turn the Adjusting Link Eccentric
clockwise, which is found in the center of the
Face Plate (2146CA). The clockwise turn of the
Eccentric will raise the Face Plate, draw more wire
from the Spool and make the overall length of the
stitch longer. If the overall length of the wire is too
long, turn the Adjusting Link Eccentric counter-
clockwise to lower the Face Plate and decrease the
draw of the wire pulled from the Wire Spool. After
the adjustment has been made, tighten the Eccentric
Binder Screw on the stitcher machine that was
previously loosened. As a rough gauge, the distance
the Face Plate is above the Bonnet (2601B) should
be equal to the work thickness. This adjustment will
have to be made every time the compression setting
on the Stitcher Machine is changed.
2301DHD Series Head and other Heads without
Face Plate Adjusting Slides (Figure 9)
Loosen the Face Plate Locating Screw (2608) found
in the center of the Face Plate (2146CA). To increase
the overall length of the stitch, raise the Face Plate
slightly by applying pressure at the bottom edge of
the Face Plate. Use a large screwdriver as a lever
under the Wire Cutter (9048) Holder area of the Face
Plate. Raising the Face Plate draws more wire from
the Wire Spool and increases the length of each staple
leg. To shorten the staple legs or draw less wire
from the Wire Spool, lower the Face Plate slightly
by tapping the top edge of the Face Plate. After the
adjustments have been made, tighten the Face Plate
Locating Screw. As a rough gauge, the distance the
Face Plate is above the Bonnet (2601B) should be
equal to the work thickness. This adjustment will
have to be made every time the compression setting
on the Stitcher Machine is changed.
Adjusting the Wire Draw
Figure 8 - Wire Draw on 2001DHD
Figure 9 - Wire Draw on 2301DHD
2146CA
2601B
more
wire
draw
less
wire
draw


2608
2146CA
9048
more
wire
draw
less
wire
draw

