Specifications

11
Always disconnect the power supply before
making any adjustments or servicing the head
WARNING
!
(2215) with the Driving Slide
Pin. (2103B) on the back of
the stitcher head. The Driving
Slide Pin must be inserted in
the lower hole of the Link.
(The lower hole of the Link
is the one opposite of the oil
hole.) With the Link held in a
vertical position, line the head
up with the machine. Engage
the machine’s Crank Pin in the
upper hole of the Driving Shaft
Connecting Link and insert the
Binder Stud Pin (2624) in the
mounting hole of the Bonnet
casting.
Push the the 2001DHD Series
Head into position until the
Bonnet Binder Stud (2609),
which is secured to the Stitcher
Head with the Bonnet Stud Pin
(2624), is fully inserted into the machine’s mounting hole and the stitcher’s Face Plate Adjusting
Link Eccentric is positioned within the hole in the Head’s Face Plate. (2132BA or 2146CA) If the
Link Eccentric is not in alignment with the hole in the Face Plate, adjust the machine’s Compression
Knob or Handle or the Face Plate until it is.
Verify that the Driver Shaft Connecting Link (2215) is squarely engaged with the Crank Pin on the
stitcher machine and the Driving Slide Pin (2103B) on the stitcher head and that they do not bind.
Secure this position with the Bonnet Stud Nut. (HN1213)
After the head is securely attached to the machine, turn the machine over manually or activate it in
jog mode, to check that the head operates freely. Until it operates freely, do not run the head under
power.
Figure 3 - Removing and Attaching Heads
* Parts shown in outline are
separated for identification
purposes only.
2215
HN1213
2609
2609B
2624
WATKISS
STYLE
MOUNTING
2609B
G50102
G50394 (4)
G50716