Specifications

Installation
8
As you carefully unpack the head, check to make sure all components were delivered and are in
good working order. Refer to Figure 1 in this manual for reference to the following pieces:
• 26/26D Manual
• Driver Release Pin
• Wire Guide Spring Assembly
• Bonnet Clamp Block and Bonnet Clamp Handle on 2601AHD, 2601DHD and
2601EHD style heads
• Bonnet Binder Stud, Bonnet Stud Pin and Bonnet Stud Nut
on 2001DHD and 2301DHD style heads
• Clincher Plate, Points and Slide (supplied with most heads)
• Driving Shaft Connector Link on 2001DHD and 2301DHD style heads
• Stitch Samples
Carefully inspect the condition of the shipping container before unpacking your 26/26D Stitcher
Head. If the container is broken or damaged and there is evidence that the stitcher head may be
damaged, immediately notify the carrier who delivered the head and the DeLuxe Stitcher Graphic
Arts Representative from whom the 26/26D Stitcher Head was purchased.
Pre-Inspection
Inspection