Specifications

Installation

As you carefully unpack the head, check to make sure all components were delivered and are in

good working order. Refer to Figure 2in this manual for reference to the following pieces:

• G8 Manual

• 2.0mm Hex Key Wrench (G20374)

• 2.5mm Hex Key Wrench (G20361)

• 3.0mm Hex Key Wrench (G20360)

• 5.0mm Hex Key Wrench (G20362)

• 7.0mm Open End Wrench (G20364)

• Complete Wire Guide Spring Plate Assembly (G20278AA)

• Adjustment Knob Assembly (G20228A)

• Short (G20279A) or Long (G20286A) Wire Guide Spring Assembly

• Clincher Plate Assembly - Thick (9086A)

• Round (9083A) or Flat (9083C) Thick Clincher Points

• Clamp Block (9002) and Clamp Block Eccentric (G20124) or Rear Clamp Pin (G20366)

and Rear Mounting Bolt (G20367 or G20341)

• Either Clincher Plate Binder Nut (2091), Bolt (9088) and Thick Clincher Slide (9093A)

or Clincher Plate Binder Nut (2091), Bolt (9088), Adjustable Clincher Slide (9084B),

Clincher Slide Adjusting Screw (9087) and Clincher Slide Adjusting Lock Screw

(UA4808.7).

• Stitch Samples

Carefully inspect the condition of the shipping container before unpacking your G8 Stitcher Head.

If the container is broken or damaged and there is evidence that the stitcher head may be

damaged, immediately notify the carrier who delivered the head and the DeLuxe Stitcher Graphic Arts

Representative from whom the G8 Stitcher Head was purchased.

Pre-Inspection

Inspection