Specifications

Installation

As you carefully unpack the head, check to make sure all components were delivered and are in

good working order. Refer to Figure 2 in this manual for reference to the following pieces:

• G20 Manual

• 2.0mm Hex Key Wrench (G20374)

• 2.5mm Hex Key Wrench (G20361)

• 3.0mm Hex Key Wrench (G20360)

• 5.0mm Hex Key Wrench (G20362)

• 7.0mm Open End Wrench (G20364)

• Complete Wire Guide Spring Plate Assembly (G20278AA)

• Adjustment Handle Assembly (G20628A)

• Short (G20679A), Medium (G20279A) or Long (G20286A) Wire Guide Spring Assembly

• Moving Clinch Clincher Plate Assembly (7253A) or (7650A) or 2-Sided Solid Clincher

Plate (7650SCP)

• Clincher Slide (18182), Clincher Slide Adjustment Block (18183), Clincher Slide Block

Clamp (18184), Clincher Slide Adjustment Screw (18186), Set Screw (UA1428.1), two (2)

Slotted Fillister Machine Screws (UA3216.4) and two (2) Round Head Machine Screws

(UA3310.3). A Clincher Binder Plate (18179) and a Clincher Slide Retaining Strap

(7256B) are included on the multi-head model Clincher Plate Assemblies.

• Flat (7024B) or Round (7257B) Clincher Points

• Two (2) Bonnet Clamp Blocks (G20501 or G20502) and Eccentrics (G20524 or G20503)

or two (2) each of the following: Rear Mounting Bolt (G20341), Rear Clamp Pin (G20376)

and Bonnet Stud Nut (HN1213)

• Stitch Samples

Carefully inspect the condition of the shipping container before unpacking your G20 Stitcher Head.

If the container is broken or damaged and there is evidence that the stitcher head may be

damaged, immediately notify the carrier who delivered the head and the DeLuxe Stitcher Graphic Arts

Representative from whom the G20 Stitcher Head was purchased.

Pre-Inspection

Inspection