Specifications

28
PROBLEM: Left Leg Too Long / Right Leg Too Short
SOLUTION: Adjust the position of the Cutter Block Assembly by moving it
away toward the Head. (See page 15)
PROBLEM: Staple Legs Too Long or Too Short
SOLUTION: Correct the overall wire draw by repositioning the Feed Slide
within the G20 Head. (See Page 16)
PROBLEM: Left Leg Missing
SOLUTION: Straighten the wire. (See page 13) The Wire Holder Assembly is
not aligned properly with the groove in the Bender Bar.
PROBLEM: Legs are Spread or Contracted
SOLUTION: Straighten the wire. (See page 13) Replace worn Bender Inserts.
(See page 23)
PROBLEM: Legs Stray Forward or Backward Consistently
SOLUTION: The Clincher Points are not aligned properly front to back.
(See page 17) Straighten the wire. (See page 13)
PROBLEM: Stitch Stray Randomly In and Out and Front to Back
SOLUTION: Straighten the wire. (See page 13) Make sure the Cutters are
aligned properly. (See page 21) Check the tensile strength of the wire or use
thicker wire.
PROBLEM: Weak crown, crown breaks off after stitch
SOLUTION: Align the Wire Holder with the grooves in the Bender Bar
(See page 13). Check the tensile strength and size of the wire being used.
PROBLEM: No wire being drawn
SOLUTION: Make sure the Feed Release Cam is turned to the “on”
position and the Feed Gears engaged. (See page 12)
Figure 22 - Troubleshooting