Specifications

11
Always cycle the stitcher machine manually after
mounting a head and before running under power
rWARNING
!
Block (G20672) and Bender Slide (G20562) are in their respective slots on the stitcher machine.
Rotate the 5mm Hex Key Wrench (G20362), in the Eccentric as shown, to secure the G20 Head to
the stitcher machine.
G20BHD
(Bolt Mount/Rail Drive)
This G20 Head comes with two (2) Rear Mounting
Bolts (G20341), Rear Clamp Pins (G20376) and
Bonnet Stud Nuts (HN1213) for mounting. Refer to
Figure 4.
NOTE: Instructions may vary with other types of
Bolt Mount / Rail Drive machines.
Insert the Rear Mounting Bolts into the holes of the
Bonnet casting and secure them with the Rear Clamp
Pins. Line the lower Mounting Bolt up with the lower
mounting hole in the stitcher machine and loosely
secure the Bolt with the Hex Jam Nut. Position the
Adjustment Block (G20592), Feed Slide Block
(G20672) and Bender Slide (G20562) approximately
where it will meet up with the rails of the stitcher
machine or a little lower. Push on the Head until the
upper Mounting Bolt is inserted into the upper
mounting hole in the stitcher machine. The
Adjustment Block, Feed Slide Block and Bender Slide
may have to manually manipulated in order to insert
the upper Mounting Bolt. Tighten both Hex Jam Nuts
to completely secure the G20 to the stitcher machine.
Figure 4 - Removing and Attaching Heads
G20672
G20341 (2)
HN1213 (2)
G20592
G20562
G20376 (2)