Specifications

Each new G20 Stitcher Head comes fully assembled with the exception of the Complete Wire Guide

Spring Plate Assembly (G20278AA), the Wire Guide Spring (G20679A, G20279A or G20286A) and

the Clincher Plate Assembly. Slip the Wire Guide Spring Bracket onto the Upper Wire Tube (G20581)

and rotate until the Bracket accommodates the wire payoff of the stitcher machine. Tighten the Socket

Head Cap Screw (G20288) to hold the Wire Guide Spring Bracket Assembly in place.

On multi-head machines, slide the Clincher Plate Assembly into the clincher mounting rail of the

stitcher. Insert the Clincher Adjustment Screw (18186) in the clincher lever assembly of the machine.

Center the Clincher Slide (18182) under the Driver Bar (G20551) and Driver* of the G20 but do not

tighten the Machine Screws (UA3310.3) in the Clincher Slide Strap (7256B), which secure the

Clincher Plate’s location until the Head is firmly positioned. On single-head machines, mount the

Clincher Plate Assembly over the two (2) pins on the clincher mounting block. Insert the Clincher

Adjustment Screw (18186) in the clincher lever assembly of the machine. Secure the Plate with the

two (2) Machine Screws (UA3310.3). (See Figure 11).

Assembly

The quality and quantity of work that can be

produced by the G20 DeLuxe Stitcher Head is

dependent upon the operator making the various

operating adjustments as accurately as possible.

The following illustrated instructions are provid-

ed so that the operator will clearly understand

how to make the various required operating

adjustments.

G20DHD, G20FHD, G20MHD and G20SHD

(Slot Mount/Rail Drive)

These G20 Head Models come with two (2)

Bonnet Clamp Blocks (G20501) and Bonnet

Clamp Eccentrics (G20524) for use on stitchers

with a T-Slot mounting rails. Refer to Figure 3.

Slide the Clamp Blocks into the T-slots on the

stitcher, as shown. Align the marks on the

Eccentrics with those on the Bonnet. Next, slide

the Head onto the Clamp Blocks, bottom one

first, and against the stitcher machine. Make sure

the Adjustment Block (G20592), Feed Slide

Figure 3 - Removing and Attaching Heads

Mounting

G20362

G20501 (2)

* A complete parts listing can be found on page 47

G20524 (2)