Operating Guide
Table Of Contents

104439 Rev. B
5
Potential scald or thermal shock injury could result due to cross ow if outlet at the shower is
blocked or restricted (e.g., pause control on showerhead). Be sure to point showerhead away
from you when re-starting ow or install inlet check valves on both supply lines to prevent
possible injury.
6
Installation
4
Valve Trim Installation
B.
2
1
3
4
Diverter Handle Installation
Slide diverter handle (1) onto diverter cartridge stem
(2), ensure that handle aligns with cartridge stem.
Install set screw (3) using an allen wrench. Place set
screw cover (4) over set screw and apply pressure
until cover is properly seated.
A.
1
2
3
Temperature handle Installation
Secure temperature control knob (1) with screw
(2). See next step for securing temperature control
cover (3).
Snap temperature control cover over temperature
control knob by rst aligning smaller tab (1) on
cover with receiving slot (2) on temperature knob.
Swing larger tab (3) to engage with snap feature
(4). Note: If dis-assembly is required, reverse
this motion, disengaging larger tab (3) from snap
feature (4) rst.
4
2
1
3
1
5
3
2
4
T27T899 & T27T999 Series
Temperature handle Installation
Attach spacer screw (1) to valve stem (2). Slide
temperature control handle (3) into place over spacer
screw (1). Install set screw (4) using an allen wrench,
place set screw cover (5) over set screw and apply
pressure until cover is properly seated.
A1.
Temperature Handle Installation Step A or A1.
Diverter Handle Installation Step B.