Operating Guide

107532 Rev. C

Potential scald or thermal shock injury could result due to cross ow if outlet at the shower

is blocked or restricted (e.g., pause control on hand shower). Be sure to point hand shower

away from you when re-starting ow or install inlet check valves on both supply lines to

prevent possible injury.

Snap temperature control cover over temperature

control knob by rst aligning smaller tab (1) on

cover with receiving slot (2) on temperature knob.

Swing larger tab (3) to engage with snap feature

(4). Note: If dis-assembly is required, reverse

this motion, disengaging larger tab (3) from snap

feature (4) rst.

Diverter handle Installation

Diverter Handle Installation

Slide diverter handle (1) onto trim sleeve (2).

Using a allen wrench, insert set screw (3) into

handle (1). Applying pressure, insert set screw

cover (4), if included, until properly seated.