User manual
Table Of Contents
- N
- Introduction
- Introduction
- Getting Started
- S
- SunScan Tutorial
- M
- Menus and Screens
- More Psion and file handling notes
- M
- Measurement options
- L
- LAI theory
- Technical Reference section
- Maintenance and repair
- Troubleshooting
- Psion Workabout
- Problems running the SunData application.
- While running SunData
- SunData reports “SunScan probe not connected”.
- SunData recognises the SunScan probe, but fails to take readings.
- On running SunData, all the system settings are scrambled.
- “Out of memory” reported on drive A:.
- “Insufficient power to write data” reported.
- When transferring files to a PC, data is transferred, but there are repeated checksum or device IO errors.
- SunScan or BFS give inconsistent light readings.
- Technical Support
- Specifications
- PAR Performance
- Appendices
- Index
68 •
••
• Technical Reference section Document code: SS1-UM-1.05
“Insufficient power to write data” reported.
• Recharge the Ni-Cd battery pack, or replace it with a freshly charged Ni-Cd pack
or two AA Alkaline cells.
When transferring files to a PC, data is transferred, but there are repeated checksum or
device IO errors.
• Reboot your PC and start again. See the advice on RS232 communications in the
SunScan Tutorial (p28).
SunScan or BFS give inconsistent light readings.
• Make sure the diffusers are clean and that the desiccant condition indicators are
blue. See the advice on PAR calibration in Measurement Options (p49).