User manual
Table Of Contents
- N
- Introduction
- Introduction
- Getting Started
- S
- SunScan Tutorial
- M
- Menus and Screens
- More Psion and file handling notes
- M
- Measurement options
- L
- LAI theory
- Technical Reference section
- Maintenance and repair
- Troubleshooting
- Psion Workabout
- Problems running the SunData application.
- While running SunData
- SunData reports “SunScan probe not connected”.
- SunData recognises the SunScan probe, but fails to take readings.
- On running SunData, all the system settings are scrambled.
- “Out of memory” reported on drive A:.
- “Insufficient power to write data” reported.
- When transferring files to a PC, data is transferred, but there are repeated checksum or device IO errors.
- SunScan or BFS give inconsistent light readings.
- Technical Support
- Specifications
- PAR Performance
- Appendices
- Index
SunScan User Manual v 1.05 Getting Started •
••
• 13
Running SunData in Windows
At this stage you may wish to install the SunData program so that it runs from within
Windows.
In Windows 3.11
The SunData diskette also contains SUNDATA.PIF and SUNDATA.ICO files for use
with Windows.
♦ In Windows Program Manager, select File, New, Program Item
♦ Specify SunScan for the Description,
SUNDATA.PIF for the Command Line, your
program directory name for the Working Directory, and
SUNDATA.ICO for the
Icon File.
Program Manager will then display the SunScan Icon.
Later on you can refine this arrangement, and call the program from a data
directory, but for the present it will get you started.
♦ To run SunData: double click on the SunScan icon to run SunScan full screen.
♦ To exit: press
Alt+F, X, or Alt+Q, Q
In Windows 95
SunData will run from a Windows 95 DOS command prompt, or from an MS-DOS
mode DOS session launched from Windows 95. Do not try to run it under a
Windows 95 non MS-DOS mode DOS session. Then follow the general principles
given above for Windows 3.11.