Installation Guide

39
TROUBLESHOOTING / DÉPANNAGE / SOLUCIÓN DE PROBLEMAS
Symptom: Alignment Recommended Action
1. The top side of the glass panel is tilted away from
the wall jamb.
Remove the glass panel from the top track and raise the roller on the bracket closest to the wall jamb.
2. The bottom side of the glass panel is tilted away
from the wall jamb.
Remove the glass panel from the top track and lower the roller on the bracket that is closest to the wall jamb.
3. The glass panel does not touch the bumper. Determine whether glass panel top or bottom is closer to the wall, and then adjust the roller closest to the wall
per #1 or #2 above.
4. The top track is cut too short. New track kit must be purchased and top track must be cut correctly. See steps 26-28.
5. The bottom track is cut too short. Seal as directed to ensure watertight seal. See steps 48 and 49. If additional sealant insufficient, new bottom
track may be required and must be purchased.
Symptom: Water Leaks Recommended Action
1. Water leaks between panels When showering, make sure the inside panel is closest to the showerhead wall.
2. Water leaks between wall jamb and the glass panel. For adjustment, see Symptom: Alignment.
3. Water leaks under the bottom track. Check for proper silicone sealant application. See steps 48 and 49. Apply more silicone sealant as needed.
Symptom: Operation (open/close) Recommended Action
1. The outside panel is difficult to move. a. Ensure sufficient clearance exists between the center divider and the glass panel. If needed, adjust the outer
rollers.
b. Ensure the panel is properly engaged over the center divider. See step 41.
c. Ensure the inside center guide is properly secured with self-tapping screw. See step 19.
d. Ensure the rollers are properly installed.
e. Clean any debris in the top track where the rollers operate.
2. The inside panel is difficult to move. a. Ensure sufficient clearance exists between the center divider and the glass panel. If needed, adjust the inner
rollers.
b. Ensure the panel is properly engaged over the center divider. See step 37.
c. Ensure the inside center guide is properly secured with self-tapping screw. See step 19.
d. Ensure the rollers are properly installed.
e. Clean any debris in the top track where the rollers operate.
Symptom: Maintenance Recommended Action
1. Excess noise or vibration. a. Check all fasteners and re-tighten as necessary.
b. Ensure bushings (DD) are installed in glass.
2. Track kit discoloration. Carefully review and follow Care and Cleaning instructions.