User manual

Chapter 2 Overview| CME-PD01
2-2 Revision October 2006, 2006PDD23000013

The address in PROFIBUS-DP can be set via two rotary address switches, ADDH
and ADDL, on CME-PD01:
ADDH used as a high 4 bits of address, ADDL used as a low 4 bits of address.
NOTE
For more information of address switches, refer to Chapter 5 Communication.

A specific 6-PIN communication cable for RJ-45, is used to connect the CME-PD01 to
VFD-E series via RS-485 interface. VFD-E series supply the 15V DC power to CME-
PD01 through this cable.

PROFIBUS-DP interface (DB9) uses a standard PROFIBUS-DP system interface. We
recommend users use the standard connector to connect CME-PD01 to PROFIBUS-
DP system. Besides, the CME-PD01 also provides a 4-PIN extended socket for users
to connect it to PROFIBUS-DP system based upon the requirements. However,
please pay attention to the assignment of A1, B1, and A2, B2 on the 4-PIN extended
socket.

CME-PD01 supports baud rates of 9.6kbaud to 12Mbaud.
2.3 Functionality

Cyclical process data exchange (PZD).

Parameter accessing: cyclical accessing of parameters (PKW).

PROFIBUS supports the control commands SYNC and FREEZE for data
synchronization between master and slaves.

Support the configuration of data structure for data exchange with VFD-E series.