User manual

Chapter 5 Communication| CME-PD01
5-4 Revision October 2006, 2006PDD23000013
11B：Change direction
00B：1st Accel / Decel time
Bit 6~7
01B：2nd Accel / Decel time
Bit 8~15 Reserved
Frequency Command
Bit 0
1：E.F. ON
Bit 1
1：Reset command
Bit 2~15 Reserved
NOTE
Table above is for reference only, please check VFD-E series user manual for details. The
control word that is mapping to the address of VFD-E series can be carried out by CME-PD01,
so the bit assignments in the user manual of VFD-E series is valid.
Status word (data from VFD-E series to DP)
Bit 0~1
LED status
00B: RUN LED light on, STOP LED light off (Drive Stop)
01B: RUN LED blink, STOP LED light up (Drive decelerate to stop)
10B: RUN LED light up, STOP LED blink (Drive standby)
11B: RUN LED light on, STOP LED light off (Drive Run)
Bit 2 1: JOG is active
Bit 3~4
00B: REV LED light off, FWD LED light up (Forward)
01B: REV LED blink, FWD LED light up (Reverse to Forward)
10B: REV LED light up, FWD LED blink (Forward to Reverse)
11B: REV LED light up, FWD LED light off (Reverse)
Bit 5~7 Reserved
Bit 8 1: Master frequency controlled by communication
Bit 9 1: Master frequency controlled by external terminal (EXT)
Bit 10 1: Operation command controlled by communication interface
Bit 11~15 Reserved