Specifications

PROFIBUS DP Slave Communicaion Module RTU-PD01
DVP-PLC Operation Manual
12
Definitions of configuration items:
Parameter Value Definition
Location 0 ~ 7
The location of DVP06AD-S at the right side of RTU-PD01. The
location of the first special I/O module at the right side of
RTU-PD01 is 0, the second is 1 and so forth. This rule is only
applicable on special I/O modules.
-10V ~ +10V
The input channel on DVP06AD-S is set to mode 0: Voltage input
mode. Input range: -10V ~ +10V
-6V ~ +10V
The input channel on DVP06AD-S is set to mode 1: Voltage input
mode. Input range: -6V ~ +10V.
-12mA ~ +20mA
The input channel on DVP06AD-S is set to mode 2: Current input
mode. Input range: -12mA ~ +20mA
CH1 input mode
CH2 input mode
CH3 input mode
CH4 input mode
CH5 input mode
CH6 input mode
-20mA ~ +20mA
The input channel on DVP06AD-S is set to mode 3: Current input
mode. Input range: -20mA ~ +20mA
Current value Current value of the input signal in all channels on DVP06AD-S
Input value mode
Average value Average value of the input signals in all channels on DVP06AD-S
Average times 1 ~ 4096 The average times
z Configuration method for DVP04DA-S and DVP02DA-S
Refer to the figure below for the relevant parameters to configure DVP04DA-S. DVP04DA-S and
DVP02DA-S have the same parameters to set, except that DVP04DA-S has two more parameters for
input channels to set than does DVP02DA-S (Therefore, only the parameter settings for DVP04DA-S
are introduced in this section).