Specifications

DELTA LTL2000 Retrometer 40
Initial Status
After executing a ZERO function the status will look
like this.
It shows that no Zero measurement has been
executed and also no Calibration.
The values for the highvoltage (VPMT) and battery
voltage are set to their default values.
The Data log status is shown.
The special status shows the setting for the MODE
Switch, the measurement counts for noise reduction,
the automatic off timer, the actual voltage on the
battery, the date and time and finally the firmware
revision # and creation data.
Finally is shown the e-mail address and the WWW
address to DELTA.
Note that the Real Time Clock and the Data
Logs normally will not be affected by a Set
ROM Defaults or a II command.