Operation Manual

9
HELPLINE No. U K / N.IRELAND 0800 328 60 20 REP. IRELAND 00 800 44 67 58 88
E-MAIL SUPPORT [e-mail]
Model Number: GT-WKe-01UK
3. Fill the required quantity of fresh, cold water.
Pay attention to the fill level display: The water level must be between MIN and MAX.
4. Close the lid again. Ensure that the lid audibly locks in.
5. Place the kettle on the base.
6. Press the on/off button , if you only intend to boil the water (100 °C).
Or set a temperature:
-Press the SET TEMP button repeatedly until the appropriate temperature LED
illuminates in the operating panel. 40, 60, 80 or 100 °C are available to select from.
- Press the on/off button within 10 seconds.
The selected temperature LED will flash and the LED of the on/off button will
illuminate.
If the boiling procedure is not started within 10 seconds, the set temperature will
be lost and the procedure must be repeated.
The boiling procedure is started and the water will be heated to the set temperature.
As soon as the selected temperature is reached:
- a signal tone sounds,
- the relevant temperature LED illuminates for another approx. 2 minutes,
- the LED of the on/off button extinguishes.
7. Remove the kettle from the base. Only hold the kettle on the handle and wait a
moment, until the water is no longer bubbling.
8. Pour the water out slowly. Do not open the lid for this.
Please note:
z If you have set e.g. 100 °C as the required temperature, the temperature LEDs for 40,
60 and 80 °C will illuminate consecutively during the boiling procedure, as soon as the
relevant water temperature has been reached.
z You can stop the boiling procedure at any time by pressing the on/off button .
z As soon as you lift the kettle off of the base, the appliance will switch off and all settings
will be lost.
z We recommend that you do not re-boil stale water. Pour it away or use the cooled
water for watering plants.