Installation Guide

COLOR #1 COLOR #2 COLOR #3 COLOR #4
COATING
PRINTING
PAGE
BLACKYELLOWMAGENTACYAN
2 of 2
-
Page 2 of 2
Graphics Page
8/7/2018
COLOR #5 COLOR #6
-PMS 200 C
Coating
Aqueous Silk
Notes Section:
ACCESS THE WEB PAGE. VOICEIQ™ MODULE LED COLOR INDICATORS TROUBLESHOOTING TIPS
QUESTIONS?
Connect your smartphone or tablet to your VoiceIQ™
Module’s Wi-Fi signal, “Delta-ABC.” Your VoiceIQ™
Module will have a unique identifier in the Wi-Fi
network name, shown here as “ABC.”
Be sure to disconnect your your smartphone or
tablet from cellular data. Open a browser and enter
the URL 10.10.10.1 for product setup. Follow the steps
on screen.
Bookmark device.deltafaucet.com for easy access
to the Web page, where you can see settings, FAQs,
and a list of voice commands.
Look for this on your VoiceIQ™ Module under the sink, not at the faucet base.
BLINKING GREEN
Wi-Fi setup mode: indicates the VoiceIQ™ Module is trying to connect
t
o Wi-Fi. If blinking continues for more than 3 minutes, you may need
to reconnect it to your home Wi-Fi.
BLINKING RED
Blinks once every 5 seconds. This indicates that the required
AC power is not connected.
SOLID GREEN
This indicates a successful connection to Wi-Fi.
SOLID RED
This indicates an interrupted or failed Wi-Fi connection.
VOICEIQ
™
TECHNOLOGY
QUICK SETUP GUIDE
VoiceIQ™ Module for Delta® Touch
2
O® Faucets manufactured after 01/01/2018
For warranty information, visit
DeltaFaucet.com/service-parts/warranty.
If your VoiceIQ™ Module is blinking a red light every 5 seconds, there is an issue
with your power supply. Verify that the outlet you’ve plugged your module into
isn’t connected to your garbage disposal switch by plugging something else into the
outlet (lamps and other lights work best, but anything that lights up or makes noise
and doesn’t have a backup battery will work), then switching your garbage disposal
switched on, your outlet is connected to your garbage disposal and isn’t compatible
with your VoiceIQ™ Module.
If you can’t locate DELTA-ABC on your list of available Wi-Fi networks, check for a
flashing green light on your VoiceIQ™ Module under the sink. If the light is blinking
green, re-scan for Wi-Fi networks on your mobile device. If the light is blinking red,
see the above troubleshooting tip about power supply.
If the VoiceIQ™ Module setup page fails to load on your mobile device after entering
10.10.10.1, check the following:
a. If the LED light on your VoiceIQ™ Module is blinking green, it’s still in Wi-Fi
setup mode. Re-scan for Wi-Fi networks on your mobile device and connect to
“Delta-ABC” (
“ABC” is used here to mark your module’s unique identifier code).
b. If the LED light on your VoiceIQ™ Module is blinking red, it isn’t connected to
a power source. See the first troubleshooting tip listed above.
c.
the webpage.
If the device fails to connect after entering Wi-Fi network name and password and
the LED on the VoiceIQ™ Module is solid red, check the following:
a. Double-check that your Wi-Fi password was entered correctly.
b. The VoiceIQ™ Module works with 2.4 GHz Wi-Fi. If your router has both 2.4 GHz
and 5.0 GHz, make sure you use 2.4 GHz. When scanning for Wi-Fi networks on
your mobile device, only the 2.4 GHz network will appear.
10.10.10.1
device.deltafaucet.com
We’re here to help. You’ll find a full list of frequently asked questions at
device.deltafaucet.com. You’re also welcome to call our customer solutions
line at 877-652-8151.
104180 Rev. A 03/12/2019
Take command of
your kitchen with a
voice-activated faucet
that works smarter.
BEFORE YOU BEGIN. NOW, LET’S GET STARTED.
STEP 1:
water supply.
STEP 2: Remove the plastic
clip from the bottom of your
existing solenoid.
STEP 3: Remove the hose by
gently pulling it downward.
STEP 4: Slide the new VoiceIQ™
Module unit onto the bottom of
your existing solenoid.
If you need installation or troubleshooting assistance,
visit DeltaFaucet.com/VoiceIQ.
These instructions begin with an installed Delta Touch
2
0® faucet
*
. If you
have not installed your faucet yet, please follow the instructions for faucet
installation prior to installing your Delta VoiceIQ™ Module. You will also
need a smartphone or tablet and the following to complete the set-up:
Before you begin, remove the batteries from the battery pack of
your Delta Touch
2
O® faucet.
A POWER SOURCE.
Under the sink. Not
controlled by a switch.
A CONNECTED
HOME DEVICE.
Amazon® Alexa® or
Google® Assistant.
A HOME WI-FI SYSTEM.
And your login
information.
1 32 4
* manufactured after 01/01/18
STEP 5: Swivel the retainer clip
upward and click it into place.
STEP 6: Slide the hose onto the
VoiceIQ™ Module and secure it
with the retaining clip.
5 6
STEP 7: Connect the ethernet
cable to the VoiceIQ™ Module
and the existing solenoid.
STEP 8: Connect the power supply to
the solenoid and to an outlet that is
not controlled by a switch. Reinstall
Touch
2
0® solenoid batteries.* Turn on
water supply and continue set up.
7 8
* in case of power outage, touch activation
will revert to battery power.