Manual

PROBLEM
Engine will not
start (see Engine
Manual for
further engine
troubleshooting)
No or low
pressure
(initial use)
CAUSE
No fuel.
Pressure builds up after two pulls
on the recoil starter or after initial
use.
Choke lever in the ,No Choke,'
position,
Spark plug wire not attached.
Choke lever in the "Choke"
position on a "hot!' engine ot an
engine that has been ex_d to
thermal heat for a long period of
Wand not in high pressure.
_ water Supply.
.eak at high pressure hose fitting.
_le Ob_ructed: .......
Nater filter screen clogged.
Defect_ E_Z _ valve,
Air in hose.
C_ke lever intl-_ "Choke" p_itiohi
Throttle control lever is not in the
"Fast" position.
High pressure hose istoo !ong.
CORRECTION
Add Fuel,
Squeeze gun trigger to relieve
:)ressure.
Move choke to the ',Choke',
position.
Attach spark plug wire.
Move choke to the "No Choke'_
iposito.
i i !
See How to Use Spray Wand
paragraph in the Operation
Section.
Water supply must be dt I_st 5
GPM @20 PSI.
Tighten fitting. Apply sealant tape
if necessary.
See Spray Wand paregmph in the
Maintenance section for the
correct procedure.
Remove and clean filter.
Check _h Auth0rized Wan'anty
Service Center (AWSC.)
Turn off the engine, then the
water source. Disconnect the
water source from the pump inlet
and turn the water source on to
remove all air from the hose.
When there is a steady stream of
water present, turn water source
off. Re-connect water source to
pump inlet and turn on water
source. Squeeze trigger to
remove remaining air
Move choke to the "No Ch0ke !_
position.
Move throttle control lever to the
"Fast" position.
Use high pressure hose under
100 feet.
21-ENG D27918