Instruction manual

NOTE: Make certain that the spindle taper (Q) Fig. 17 and the tapered hole in the chuck (R) are clean and free of

grease, lacquer, or rust preventive coatings.

NOTE: Household oven cleaner can effectively remove any substance from the spindle and chuck. Carefully follow the

manufacturer's safety rules concerning its use.

13. Open the chuck jaws as wide as possible by turning the chuck sleeve (S) Fig. 18. Hold the chuck on the taper

of the spindle and tap with a rubber mallet (T) or a block of wood and hammer to set the chuck (Fig. 18).

IMPORTANT: To avoid damage to the chuck, DO NOT drive the chuck on the spindle with a metal hammer.

10. Thread the stud of the clamp handle (M) Fig. 14 in the hole in the rear of the table bracket.

11. Seat the drill press head (N) Fig. 15 on the column. Align the head (A) Fig. 15A, with the table (B) and base (C).

Tighten the two head locking screws (O) Fig. 15 with the supplied wrench.

12. Thread the three pinion shaft handles (P) Fig. 16 in the three tapped holes located in the pinion shaft.

Fig. 14

Fig. 15

Fig. 15A

Fig. 16

Fig. 17

Fig. 18