Specification

Liberty Hardware Manufacturing Corporation • 140 Business Park Drive • Winston-Salem, NC 27107 • 800.542.3789 • www.libertyhardware.com
©2011 LHMC, A Masco Company
see what Delta can do
"B"
"A"
2-3/4"
69.9mm
1-1/2"
38.1mm
3-1/8"
79.0mm
Lahara -
Decorative Grab Bar
Grab Bar
LENGTH 9"
228.6 mm
16"
406.4 mm
24"
609.6 mm
DIM "A" 9"
228.6 mm
16"
406.4 mm
24"
609.6 mm
DIM "B" 12-1/8"
307.6 mm
19-1/8"
485.4 mm
27-3/32"
688.6 mm
MATERIALS: Grab bar is constructed using 1-1/4" diameter 20 gauge 304
stainless steel tubing. Decorative posts and trim rings are cast
in zinc.Trim rings are held in place using a friction fit. Meets
ADA and ANSI A117.1-2003 for form and load bearing requirements.
INSTALLATION: Install grab bar with 3-#10x2-1/2" flat head stainless steel
screws provided for each end wall flange. Slide cover flanges
over wall flanges and press firmly to complete installation.
OPTIONAL FASTENER INFORMATION:
Wall studs or wood blocking is preferable behind all wall
surfaces. If wood blocking is not available. The following
fasteners are suggested: Non-Stud Wall anchor.
SPECIFICATION: Surface mounted grab bar shall be model_______________________________
(fill in model number)by Liberty Hardware Manufacturing Corporation.