Instruction manual

12
REMOVE THE BAT-
TERY.
1. Loosen the bevel adjustment
locking lever (K) Fig. 13.
2. Tilt the saw base until the
desired graduation line on the bevel
segment (L) Fig. 13 lines up with the
indicating mark (M) Fig. 13 on brack-
et.
3. Tighten the bevel adjustment
locking lever to the locked position
and press down firmIy.
TO ADJUST FOR BEVEL CUTS
Fig. 13
90° POSITIVE STOP
This saw is equipped with an
adjustable positive stop for 90° (N)
Fig. 14. Although this stop has been
set at the factory, check it occasion-
ally to ensure accuracy.
REMOVE THE BAT-
TERY.
1. Loosen the bevel adjustment
locking lever (K) Fig. 13 and position
the base for 90° cuts, being sure that
the top of the base is in contact with
the bottom of stop screw (N) Fig. 14.
Tighten the locking lever.
2. Turn the saw upside down,
retract the telescoping guard and
check the squareness of blade (Fig.
15).
TO ADJUST 90° POSITIVE STOP
LINE OF CUT INDICATOR
A line of cut indicator 16 is provided
at the front of the base. The left edge
(A) Fig. 16, of the notch, is used to
follow a line when making 90° cuts.
The right edge (B), of the notch, is
used to follow a line when making
45° cuts.
3. If adjustment is necessary,
loosen the bevel adjustment locking
knob, keeping the top of the base in
contact with the stop screw. Turn the
stop screw until the angle is correct.
Fig. 15
Fig. 14
K
L
M
Fig. 16
A
B
N