Installation Guide

INSTALLATION

Mark unit position on floor and through drain

opening.

Mark the locations of the studs on the flange of the

base.

NOTE: These marks are used to verify base location

after drain is installed in Step 4 and outline where

adhesive is applied.

Position base in corner. Check for level left to right and

front to back.

IMPORTANT: If the subfloor is not flat and level, use

leveling compound or mortar bed to ensure that the

base is level (shown in Step 5).

NOTE: If using the matching wall set, install the base

against drywall or green board, not against the studs.

This is so that the wall set does not overhang the base.

78326 Rev. D

Remove base from corner and drill 3/16" pilot holes in

flanges where stud locations have been marked.

NOTE: It is recommended to put masking tape on the

base to protect the surface from drill chuck damage.

Use a stud finder to locate studs. Mark stud locations on

wall and base.

NOTE: If studs cannot be located, use dry wall anchors.

For base installation

with matching wall set only.