User's Manual
Table Of Contents
- Preface
- Table of Contents
- Chapter 1 Introduction
- 1.1 Receiving and Inspection
- 1.2 Appearances
- 1.3 Installation Steps
- 1.4 Storage
- Chapter 2 Installation and Wiring
- Chapter 3 Start Up
- Chapter 4 Digital Keypad Operation
- Chapter 5 Parameters
- Chapter 6 Fault Code Information
- Chapter 7 Troubleshooting
- 7.1 Over Current (OC)
- 7.2 Ground Fault
- 7.3 Over Voltage (OV)
- 7.4 Low Voltage (Lv)
- 7.5 Over Heat (OH)
- 7.6 Overload
- 7.7 Keypad Display is Abnormal
- 7.8 Phase Loss (PHL)
- 7.9 Motor cannot Run
- 7.10 Motor Speed cannot be Changed
- 7.11 Motor Stalls during Acceleration
- 7.12 The Motor does not Run as Expected
- 7.13 Electromagnetic/Induction Noise
- 7.14 Environmental Condition
- 7.15 Affecting Other Machines
- Chapter 8 Maintenance and Inspections
- Appendix A Specifications
- Appendix B Accessories
- Appendix C How to Select the Right AC Motor Drive
- Appendix D CE
Chapter 5 Parameters|VFD-S Series
Revision August 2006, SE08, SW V2.61 5-21
bit 5 bit4 Bit 3 bit 1 Setting for Pr. 0-09
0 0
0
1 2
0 8 (factory setting)
0
1
1 10
0 16
0
1 18
0 24
0
1
1
1 26
0 32
0
1 34
0 40
0
1
1 42
0 48
0
1 50
0 56
1
1
1
1 58
When Pr. 0-09 is set to b5=0, Pr. 0-09 setting will be saved after power on again.
When Pr. 0-02 is set to d10, all parameters (includes Pr.0-09) will be set to factory setting.