User Manual
v1.0.3
21
2.2.8 Secure middle cover and front cover
1. Recover the middle cover on the EVSE and secure the
middle cover by using Torx T20 screwdriver.
Torque: 1.2 N·m (10.5 lb·in)
Note: rubber sealing shall be put on the appropriate
position before recovery.
2. Recover the front cover on the EVSE.
3. Secure the screw located at the bottom of front cover by
using a Torx T20 screwdriver.
Torque: 0.5 N·m (4.4 lb·in)
2.2.9 Enabling the Charging Function
The key switch is located on the side of the product. The
EVSE is authorized to charge when the key switch is in the
“On” position.
Note: This applies only, if the Authorization mode is set to
Key switch.
3 Operation
Turn on the upstream breaker. The indicator flashes in yellow during a system self-test. After the self-test