User Manual

v1.0.3

2.1.4 (Optional) emergency button

Installers shall install a waterproof box

(at least IP 44) and an isolator switch that both complies with local

codes. Installers assemble the MCB

and Type

A RCD in the waterproof box, then install the Isolator switch at

front end of the box, as shown in below circuit wiring diagram.

Input phase

Diagram

Single phase

Three phase

2.2 Installation steps

2.2.1 Remove front cover and middle cover

1. Remove the screw located at the bottom of front cover by

using a Torx T20 screwdriver.

2. Pull the front cover upward to separate from the EVSE.