Installation Guide

10490-422
Rev. 12/18/09
Crossover, Chest, Innerside, Topside,
Underbed Truck Boxes, &Trailer Tongue Storage Boxes
******************** IMPORTANT INFORMATION********************
Please Read and Save This Form
In the event you need to obtain Replacement Parts, we will need the Model Number of your Delta product. Please locate the Model Number
of your product and list it in the space below.
Model No._______________________________ Date Purchased_______________________________
KEYS
Your Delta product is shipped with two keys. We have hundreds of different locks and key patterns to fit the locks. The Key Code for the key
to fit the lock(s) for your Delta product is stamped on the key and on the cover of the key entry slot of the lock.
You will need this Key Code to obtain additional or replacement keys. Write the Key Code in the space below for future reference.
Key Code_______________________________
GAS SPRING AND LID LIFTS
Many of our products have one or two Gas Spring Lid lifts to assist with opening and closing the lid.
To obtain a replacement Gas Spring Lid Lifts used on your product, we will need the Model Number that appears on a label on the barrel of
the Gas Spring. Please locate the code on the Gas Spring and write it in the space below for future reference.
Gas Spring Lid Lift Model No._______________________________
TO OBTAIN KEYS, GAS SPRING/LID LIFTS, AND REPLACEMENT PARTS
Contact our Customer Service Department at 800-643-0084 and Press 1 between the hours of 8:30 AM and 4:30 PM Central Time Monday –
Friday. Or, by email at [e-mail]
To help us serve you, please have the above information available. We will need a street address to send you the item(s) you request.
Orders for Keys, Gas Spring Lid Lifts and other Replacement Parts are normally shipped within two business days.
Prices for Parts do not include shipping charges and are subject to applicable taxes.
You can send a money order or personal check for parts orders. COD shipments not available.
We also accept MasterCard and Visa information only by phone. Do not send Credit Card information by email for your protection.
ADJUSTABLE STRIKER INSTRUCTIONS
Some truckboxes are equipped with Adjustable Strikers. The adjustable striker assembly may be adjusted horizontally or
vertically by loosening the lock nuts and repositioning the striker bracket (B) or striker pin (C) as required. For best
results, loosen only one lock nut at a time.
• The horizontal adjustment
(if necessary) should be made
first.
• Loosen the lock nut (A) at the top of the striker assembly.
• Move the striker bracket (B) so the striker pin (C)
passes just to the left of the guide plate (D) as the lid
is closed. The striker pin (C) should not make contact
with the guide plate (D).
• Positioning the striker pin (C) too far to the left will
prevent the latch hook (E) from closing fully.
• Re-tighten the lock nut (A).
• For vertical adjustment
:
• Loosen the striker pin lock nut (F) on the back side of
the striker bracket (B).
• Move the striker pin (C) up or down to achieve the
desired lid tightness. Striker pin (C) should be
positioned to allow the lid to close just tight enough to
seal against the weather stripping. Moving Striker Pin
(C) too far down will make the lid difficult to close.
• Re-tighten the lock nut (F).
(see back for more information)