Installation Guide

6
P/N 27794 09/13
WALL INSTALLATION (Continued)
7. Verify Side Panel Fit
◘ Position and verify that side panels are straight and square.
8. Drill Holes in Side Panel Flange
Drill 3/16” holes at all stud locations on top flanges and along
side flanges every 12" to 18" apart.
!
CAUTION: Drill 3/16" clearance holes into anges only.
Do not drill 3/16" holes directly into studs. Drill chuck can
damage panel. Use an extended bit holder to reduce risk of
drill chuck hitting panels.
5. Prepare for Plumbing Fixtures
XX
Y
Y
XX
Y
Y
◘ Measure and mark location for plumbing fixtures on back
of side panel.
!
CAUTION: Drill chuck can damage panel. Drill holes from
back side of side panel.
◘ Using proper size hole saw, cut out plumbing fixture holes
from back side of panel.
6. Apply Fire Retardant Pad
Back of
side panel
◘ Remove backing from self-adhesive pad.
◘ Center pad over mixing valve hole and press firmly onto
back side of panel.
◘ Using a utility knife, trim pad to reveal mixing valve hole