Technical data

--- 20 ---
11-5. No-load Current
After no-load operation for 30 minutes, the no-load current values should be as follows.
Voltage, Freauency
No-load current
115 V, 60 Hz
7.4 A Max.
11-6. Reassembly Requiring Adjustment
(1) Adjustment of squareness between the saw blade (dummy disc) and the fence
After disassembly/reassembly or replacement of the Base [74], the
Table [60], the Fence [44] or the Angle Regulator [32], it is
necessary to check the squareness between the saw blade (or
dummy disc) and the Fence [44], and perform adjustment as
necessary if they are not at an exact right angle with relation to each
other. Adjustment procedure is as follows.
First, position the saw blade (or dummy disc) so that it is in the exact
center of the groove on the Table [60] which houses the Table Insert
[67]. Next, as illustrated in Fig. 22, place a square so that it is flush
against the side surface of the saw blade (or dummy disc), and move the Fence [44] as necessary so that it is
in an exact right angle with relation to the saw blade (or dummy disc). Finally, tighten the two Hex. Bolts M10
x 35 (W/Washers) [42] to fix the Fence [44] in position.
*Dummy disc: A dummy disc is a toothless disc with the same external diameter as a saw blade, and is used to
perform accurate inspection and adjustments.
(2) Confirmation of saw blade height
The lower limit of the saw blade cutting depth is factory-adjusted so that when the saw blade is fully lowered,
its cutting edge is 24 to 29 mm (1" to 1-1/8") below the upper surface of the Table Insert [67]. Lower the saw
blade and confirm that it stops at the correct position.
(3) Adjustment of saw blade lower limit position
When adjusting the lower limit of the saw blade, be sure to use a saw blade with an external diameter of 255
mm. Failure to properly adjust the lower limit position of the saw blade may result in the following problems.
1 Inability to obtain the maximum cutting capacities of the machine
2 There is a danger that the saw blade may come in contact with and cut into the Table [60].
The lower limit of the saw blade cutting depth is adjusted at the factory so that when the saw blade is fully
lowered, its cutting edge is 24 mm to 29 mm (1" to 1-1/8") below the upper surface of the Table Insert [67].
If this position is lower than the specified values, confirm without fail that it does not come in contact with the
Table [60].
If it is necessary to adjust the saw blade lower limit, loosen the Nut M10 [76] on the Adjust Screw M10 [77],
and turn the Adjust Screw M10 [77] if necessary.
By turning the Adjust Screw M10 [77] clockwise, the saw blade lower limit is raised.
By turning the Adjust Screw M10 [77] counterclockwise, the saw blade lower limit is lowered.
On completion of adjustment, ensure that the Nut M10 [76] is properly tightened.
[Caution]
Perform the adjustment carefully to ensure that the saw blade does not cut into the Table [60].
Square
Fence
Saw blade or
dummy disc
Fig. 22