Technical data

--- 8 ---
8. ADJUSTMENT AND OPERATIONAL PRECAUTIONS
8-1. Confirmation of Saw Blade Lower Limit Positioning
The lower limit of the saw blade cutting depth is factory-adjusted
so that when the saw blade is fully lowered, its cutting edge is
24 mm to 29 mm (1" to 1-1/8") below the upper surface of the
table insert. Lower the saw blade and confirm that it stops at the
correct position.
If it is necessary to adjust the saw blade lower limit, loosen the
10 mm lock nut on the 10 mm depth adjustment screw, and turn
the 10 mm depth adjustment screw if necessary. (See Fig.5)
10 mm Depth
adjustment
screw
10 mm
Lock nut
Fig. 5
[Caution] Perform the adjustment carefully to ensure that the saw blade does not cut into the table. Also,
on completion of adjustment, ensure without fail that the 10 mm lock nut is securely tightened.
8-2. How to Use the Vise Ass'y
(1) The vise ass'y can be mounted on the left side of the
base, and can be raised or lowered according to the
height of workpiece.
1 Insert the support of the vise ass'y into the hole
located on the front of the base.
2 Then tighten the 5 mm wing bolt, as shown in Fig. 6.
3 Turn the knob to thoroughly clamp the workpiece.
[NOTE] The support has two locking grooves into which
the tip of the 5 mm wing bolt is designed to fit, to
lock the vise ass'y in the desired position.
(2) The vise ass'y can be mounted on either the left side
fence or the right side fence, and can be raised or
lowered according to the height of the workpiece.
1 Insert the support of the vise ass'y into the hole
located on either the left side fence or the right side
fence.
2 Then tighten the 5 mm wing bolt, as shown in Fig. 7.
3 Turn the knob to thoroughly clamp the worikpiece.
Knob
Fig. 6
Vise ass'y
Support
Groove
Base
5 mm
Wing bolt
Knob
Fig. 7
Vise ass'y
Fence
5 mm
Wing bolt
[Caution] Always confirm that the motor head does not contact the vise ass'y when it is lowered for
cutting. If there is any danger that it may do so, loosen the 5 mm wing bolt slightly and move
the vise ass'y to a position where it will not contact the saw blade.
Also, always confirm that the vise ass'y is mounted on the right side fence before using the saw
for compound cutting operations (miter + bevel cutting).