Full Product Manual

ManualsBrandsDelta ManualsMiter Saws12 in. Dual Bevel Sliding Cruzer Miter Saw

22 23

TIGHTEN

LOOSEN

ADJUSTMENTS

DEPTH STOP ADJUSTMENT

FENCE EXTENSION

BEVEL LOCK TENSION ADJ.

ALIGN BLADE TO FENCE CONT’D

This miter saw is equipped with an adjustable depth stop for

making through cuts and non-through cuts.

Refer to Figure 33 and follow these instructions in

order to set the depth stop at a specific cut depth:

rotate the stop bracket (C) counterclockwise into the down

position. The cut depth can now be adjusted by turning the

depth adjustment screw (D).

Refer to figure 33 and follow these instructions in

order to make a through cut: rotate the stop bracket (C)

clockwise into the up position.

This saw is equipped with an adjustable extension fence.

To extend or retract the fence refer to Figure 34 and follow

these instructions: Loosen the lock knob (E) by rotating

counterclockwise and the slide the fence (F) into the desired

position. Make sure to re-righten lock knob (E) by rotating

clockwise.

Refer to Figure 35 and follow these instructions in order to

adjust the bevel lock tension: tighten/loosen the M10 nut (G)

located on the backside of the saw. Make sure to lift the bevel

lock/unlock handle into the unlocked position before adjusting

the M10 nut. Do not overtighten.

Always check to make sure lock knob (E) is

tightened before making a cut. Failure to do so may result in

injury.

Figure 33

Figure 35

Figure 34

NOTE: Make sure the square contacts the flat part of the

blade and not the teeth.

6. If the blade face is not ush with the square you will

need to adjust the miter detent plate

See Figure 32

7. Loosen the four screws (A) and move the miter table to

adjust the miter detent plate position. Set so the fence

and blade are ush against the combination square.

Make sure the miter lock knob is not locked, so the

miter detent plate may be adjusted.

8. Re-tighten the four screws and re-check the blade-to-

fence alignment.

NOTE: This saw has two scale indicators, one on the bevel

scale and one on the miter scale. After squaring adjustment

have been made, it may be necessary to loosen the indicator

screws (B) and reset them to zero.