Operating Guide

ManualsBrandsDelta ManualsMiter Saws10 in. Dual Bevel Sliding Cruzer Miter Saw

20 21

Figure 29

ADJUSTMENTS

Figure 30

ALIGN THE BLADE TO TABLE

ALIGN THE BLADE TO FENCE

Your saw is calibrated at the factory to cut true. Over time the

saw’s calibration may drift and will need to be re-calibrated.

See Figure 29

1. Unplug the Saw

2. Lower the saw head all the way down to the transport

position and engage the saw head lock pin to hold it

in place. Push the saw head into the fully retracted

position and engage the slide prevention lock to hold it

in place.

3. Set the miter position to 0 degrees and engage the

miter lock knob so the table will not move.

4. Set the bevel position to 0 degrees. Engage the bevel

latch lever, so the detent pin locks into the bevel detent

plate.

5. Place a combination square (A) against the table and

the face of the saw blade .

NOTE: Make sure the square contacts the flat part of the

blade and not the teeth.

6. Rotate the blade by hand and check the blade-to-table

alignment at several points. If the blade face is not ush

with the square you will need to adjust the bevel detent

plate.(B)

7. Loosen the three screws (C) and adjust the bevel detent

plate position. Set so the table and blade are flush

against the combination square. Make sure the bevel

lock/unlock handle is not locked, so the detent plate

may be adjusted.

8. Re-tighten the three screws and re-check the blade-to-

table alignment.

NOTE: This saw has two scale indicators, one on the bevel

scale and one on the miter scale. After squaring adjustment

have been made, it may be necessary to loosen the indicator

screws (D) and reset them to zero

Your saw is calibrated at the factory to cut true. Overtime the

saw’s calibration may drift and will need to be re-calibrated.

See Figure 30

Unplug the Saw

1. Lower the saw head all the way down to the transport

position and engage the saw head lock pin to hold it

in place. Push the saw head into the fully retracted

position and engage the slide prevention link to hold it

in place.

2. Set the miter position to 0 degrees and allow the miter

detent to lock into position.

3. Set the bevel position to 0 degrees. Engage the bevel

lock handle to lock bevel angle.

4. Place a square (E) against the fence and the face of the

saw blade .

INSTRUCTIONS CONTINUED ON NEXT PAGE

LOCK

UNLOCK

lock

unlock