Technical data

309030 9
Setup
9400A
9399A
Fig. 6
KEY
N Cylinder Air Inlet: accepts 1/4 in. (6.3 mm) O.D. tubing
P Atomization Air Inlet: 1/4–18.6 npsm
R Fan Air Inlet: 1/4–18.6 npsm
S Fluid Inlet: 3/8–18.6 npsm
T Fluid Outlet (circulating gun only): 3/8–18.6 npsm
N
PR
FAN
CYL
ATOM
S (or T)T (or S)
Side Mounted Manifold
Ports
Bottom Mounted Manifold
Ports
N
P
R
FAN
CYL
ATOM
S (or T)
T (or S)
3. Flush the Spray Gun.
Before putting any paint through the spray gun, flush
the gun out with a solvent that is compatible with the
fluid to be sprayed, using the lowest possible fluid
pressure and a grounded metal container.
WARNING
PRESSURIZED EQUIPMENT HAZARD
To reduce the risk of a serious injury whenever you
are instructed to relieve pressure, follow the Pres-
sure Relief Procedure on page 13.
4. Relieve the Pressure.
5. Position the Air Cap
Rotate the air cap as needed to achieve the desired
spray pattern direction.
Vertical Pattern
Horizontal Pattern
Fig. 7
02020