Technical data

309030 7
Installation
Mount the Gun
To mount the gun on a reciprocating arm [0.5 in. (13
mm) diameter maximum], insert the bar (A) through
the hole in the manifold as shown in Fig. 2. Secure the
gun to the bar by tightening the mounting screw (B).
The tip of the gun should be 6 to 8 inches (150 to 200
mm) from the surface of the object being sprayed.
KEY
A Mounting Bar
B Mounting Screw (on
bottom of manifold)
Fig. 2
A
B
9424A
To mount the gun on a stationary support, see Fig. 3.
Also refer to the Mounting Hole Layout on page 29.
Attach the gun to the support with two M5 x 0.8
capscrews (C). The screws must be long enough to
engage the threaded holes in the gun manifold to a
depth of 1/4 in. (6 mm). The tip of the gun should be 6
to 8 inches (150 to 200 mm) from the surface of the
object being sprayed.
9417A
KEY
C M5 x 0.8 Capscrews
Fig. 3
C