Installation Guide

6
3
1
1
2
2
Feed tube(s) (1) down through
center hole in sink. OPTION: If sink
is uneven, use silicone sealant under
the gasket. Secure faucet to sink with
mounting nuts (2) supplied with
your faucet.
For deck mount models.
Faucet Installation
Deck Mount
Single Hole Mount
Feed tubes (1) down through remaining
hole in sink. OPTION: If sink is uneven,
use silicone sealant under the gasket.
Secure faucet to sink with mounting brack-
et, spacer (for thin mount only) and nut (2)
supplied with your faucet.
For single hole mount models.
2
2
2
7
4
1
2
3
1/2" (12.70mm) IPS
Note: Be careful when bending the
copper tubing. Kinked tubes will void
the warranty. Choose hook-ups for 1/2"
I.P.S. connections: (1) Ball nose riser (3/8"
O.D. copper tubing), or (2) 1/2" I.P.S. fau-
cet connector. Use the enclosed coupling
nuts (3) with the ball nose risers (1).
Supply Line Connections
For models with fittings.
Deck Mount
Deck Mount
1
1
2
1
2
1/2" (12.70mm) IPS
3
5
2
3
1
Remove aerator (1) and turn faucet
handle (2) to the full on mixed position.
Turn on hot and cold water supplies (3)
and flush water lines for one minute.
Important: This flushes away any
debris that could cause damage to
internal parts.
Check all connections at arrows for
leaks. Re-tighten if necessary, but do
not overtighten.
Flush the System and
Check for Leaks
Important: Use two wrenches when
tightening. Do not over tighten.