Installation Guide

13 / 14 Series Installation
3
Showerhead and Tub Spout Installation
FOR SHOWERHEAD INSTALLATION: Connect top
outlet (1) to shower arm (2) with proper fittings. To pre-
vent damage to finish on shower arm, insert wall end
of shower arm into shower flange (3) before screwing
arm into riser connection. Thread showerhead (4) onto
shower arm. Apply plumber tape to pipe threads on
both ends. Do not overtighten showerhead.
A.
-I- MODELS: To
combine the two
showers, insert the
top tab (1) on the
handshower into
the slot (2) of the
showerhead. Push the
handshower into the
showerhead until the
two parts snap together.
B.
-I- Models
3
2
1
4
2
1
4
3
Slip-On Installation
The copper tube (1) must be 1/2” nominal copper.
Important: If it is necessary to cut the copper tube,
the end must be chamfered free of burrs to prevent
cutting or nicking O-ring inside the spout. Slide spout
over copper tube flush with the finished tub or wall
surface. Tighten set screw (2), but do not overtighten.
1
FOR TUB SPOUT INSTALLATION:
Refer to the installation instructions supplied with your spout. Do not connect deck mount
spouts to in-wall valves. Do not use hand showers connected in lieu of a tub spout to a
tub/shower valve. Do not use PEX tubing for tub spout drop.
B-1
B-2
B-3
Iron Pipe Installation
Install threaded pipe nipple (1) to extend past
finished wall. Apply plumber tape to threads on
pipe nipple and screw on tub spout.
Copper Sweat Installation
Remove O-ring (1) from adapter (2). Solder adapter
to tube taking care to keep solder away from O-ring
groove. CAUTION: NO SOLDER PERMITTED ON
OUTSIDE DIAMETER OF ADAPTER ADJACENT
TO O-RING GROOVE. Cut off tube (3) and replace
O-ring on groove of brass adapter. Thread tub/spout
onto adapter, taking care not to damage O-ring, and
hand tighten until spout is firmly against finished
wall and all slack is taken up behind wall.
2
1
1
23
7