User's Manual

UMAC Turbo CPU/Communications Board Hardware Manual
Ethernet Software Setup 22
Windows OS TCP/IP Setup
Ethernet mode of communication is supported by dedicated network only. A network card must be
configured on the computer to which the UMAC Turbo CPU/Communications Board connection is used
before completing the following steps. Further, a crossover Ethernet cable or a private hub along with
two straight cables is required for this setup. (See the RJ45 section of Hardware Setup.)
1. From the control panel, select properties of the network card that will communicate to UMAC Turbo
CPU/Communications Board via Ethernet.
2. Highlight the Internet Protocol (TCPIP) and select properties.
3. Write the private area IP address (e.g., 192.6.94.2) for this card and enter the subnet mask
(255.255.255.0) in the provided spaces.
4. Close the Properties page and restart the computer. The Ethernet card configuration on the computer
is complete. Note that the last digit in the IP address field must be a different value from any IP
addresses set via the EthConfigure program.