User's Manual

UMAC Turbo CPU/Communications Board Hardware Manual
Ethernet Software Setup 20
ETHERNET SOFTWARE SETUP
Note:
Note that for proper USB/Ethernet communication the host address as set by the
12 position switch, SW1, must be set to the default of 528 (210h).
IP Setup
Using the Ethernet port requires Pewin Pro with at least Service Pack 2.0. Earlier revisions of software
are not capable of communicating with the Ethernet port. Ethernet devices are configured by launching
the Eth2Configure.EXE application, provided by Delta Tau as a part of the Pewin 32 Pro Suite or
any other Delta Tau standard installation. Installation and configuration of Ethernet devices is
independent of the operating system. Therefore, Ethernet devices are compatible with Windows NT 4.0,
in addition to Windows 98/ME/2000 and Windows XP.
To configure the UMAC Turbo CPU/Communications Board side, run the application
Eth2Configure.EXE from the Programs\Pewin32Pro\ program group. This application is provided
as part of the standard installation and is placed in c:\Program files\Delta Tau\Common\ folder. The
UMAC Turbo CPU/Communications Board side comes preprogrammed with a default IP (internet
protocol) address of 192.6.94.5 stored in an on-board EEPROM. To change the IP address stored in
the EEPROM, plug in the USB cable to reconfigure the card after powering on the UMAC.
When launching the Eth2Configure.EXE program with the USB cable not plugged into the Ethernet
card, the following message displays. If the default IP address of the UMAC Turbo
CPU/Communications Board does not need to be changed, click OK to the run the EthConfigure
program.