User's Manual

Turbo PMAC2 Eth Ultralite Manual
INTRODUCTION
4
Part Number Definition
Based on the different options available for the Turbo PMAC 2 Eth Ultralite, there will be a
single line part number used for ordering and identification. The assigned part number is based on
the following chart:
5 - 3 8 6 2 - 2 - 0
Turbo PMAC2 ETH Ultralite
Communication Options
C F H
A
F
H
2 - Opt. A
MACRO -ring
fiber optic interface
3 - Opt. C
MACRO -ring
RJ -45 electrical interf.
Axis / MACRO Node Options
2 – Opt. 1A 8 servo, 6 I/O
and 2 communic. Nodes
(Standard)
3 – Opt. 1B 16 servo, 12 I/O
and 4 communic. nodes
4 – Opt. 1C 24 servo, 18 I/O
and 6 communic. nodes
5 – Opt. 1D 32 servo, 24 I/O
and 8 communic. nodes
H
G
C0 - Opt. 5C0 80MHz
DSP 563xx CPU
256 Kx24 SRAM
1 Mx8 flash*
(Standard)
C3 - Opt. 5C3 80MHz
DSP 563xx CPU
1024Kx24 SRAM
4 Mx8 flash*
F3 - Opt. 5F3 240MHz
DSP 563xx CPU
1024Kx24 SRAM
4 Mx8 flash*
CPU / Memory / Firmware
Options
C
2 - PMAC2 (Standard)*
D
D
0 - No Option
3 - Opt. 18A
Electronic board
Identification
A B
B
LK
00 -No Additional * Options
xx - Factory assigned digits
for Additional * Options
K
L
Factory Assigned Options
* If Opt. 10xx (specific firmware version) or any other Additional Option is required,
contact factory for digits
K and L (Factory Assigned digits).
If Opt. 10xx is not ordered the latest firmware is used.
4 - No Option
(Standard)
5 - Opt. 2B
Dual Port. RAM
6 - Opt. 15F
ModBus Comm.
7 - Opt. 2B & Opt. 15F
Dual Port. RAM
&
ModBus Comm.
E
J
E
G
0 - No Options
1 - Opt. G1
Profibus Master
2 - Opt. G2
Profibus Slave
3 - Opt. G3
DeviceNet Master
4 - Opt. G4
DeviceNet Slave
5 - Opt. G5
CanOpen Master
6 - Opt. G6
CanOpen Slave
7 - Opt. GB
CC-Link Slave
J
0 - No Options
1 - Opt. 12
2 -channels 12-bit
A /D converter &
1 12-bit D/A converter
Other Options
For detailed information on any of these options, please refer to the previous section of this
manual.