User's Manual

Turbo PMAC2 Eth Ultralite Manual
HARDWARE SETUP
6
The controller is mounted to the back panel with four M4 screws and internal-tooth lock washers.
It is important that the teeth break through any anodization on the controllers’s mounting gears to
provide a good electrically conductive path in as many places as possible. Mount the controller on
the back panel so there is airflow at both the top and bottom areas of the controller (at least three
inches).
Caution:
Units must be installed in an enclosure that meets the environmental IP
rating of the end product (ventilation or cooling may be necessary to
prevent enclosure ambient from exceeding 45° C [113° F]).
Mechanical Drawing
The figures below show the mounting dimensions of the controller.