User's Manual

Geo MACRO Drive User Manual
112 Connectors
X12: USB Universal Serial Bus Port
Pin # Symbol Function
1 VCC N.C.
2 D- DATA-
3 D+ DATA+
4 GND GND
5 SHELL SHIELD
6 SHELL SHIELD
This connector is used only to change the operational firmware or to perform basic software diagnostic
operations. The user can use a serial port terminal window such as Microsoft
®
HyperTerminal to
communicate with the MACRO Device. Set the serial port communication settings as follows:
Baud Rate: 38400
Data Bits: 8
Parity: None
Stop Bits: 1
Flow Control: None
If Pewin32 Pro software is installed, then the USB device should be recognized by the operating system.
If Windows does not recognize the device, contact the factory for assistance.