Installation manual

GEO Direct PWM Amplifiers – Preliminary Documentation
Unpacking 7
UNPACKING
Open the box and remove all the contents. Remove all packing material and equipment from the shipping
container. Be aware that some connector kits and other equipment pieces may be quite small and can be
accidentally discarded if care is not observed when unpacking the equipment. Do not dispose of shipping
materials until the packing list has been checked.
Electronic components in this amplifier are design-hardened to reduce static sensitivity. However, proper
procedures should be used when handling to avoid damage to equipment.
Upon receipt of the equipment, inspect components to ensure that no damage has occurred in shipment. If
damage is detected, notify the carrier immediately. Check all shipping material for connector kits,
documentation, diskettes, CD-ROM, or other small pieces of equipment.
Use of Equipment
The following guidelines describe the restrictions for proper use of the GEO PWM:
• The components built into electrical equipment or machines can be used only as integral components
of such equipment.
• The GEO Drives are to be used only on grounded three-phase industrial mains supply networks (TN-
system, TT-system with earthed neutral point).
• The GEO Drives must not be operated on power supply networks without a ground or with an
asymmetrical ground.
• If the GEO Drives are used in residential areas, or in business or commercial premises, the user must
implement additional filter measures.
• The GEO Drives may only be operated in a closed switchgear cabinet, taking into account the
ambient conditions defined in the environmental specifications.
Delta Tau Data Systems, Inc., guarantees the conformance of the GEO Drives with the standards for
industrial areas stated in this manual, only if Delta Tau components (motors, cables, controllers, etc.) are
used.